Menu Operations - JVC D-ILA DLA-M2000LU Instructions Manual

Menu Operations

You can adjust picture quality, set functions, get information on the input video signal, etc. using the menus. From the
following menu transition diagrams, you can see the overall menus and basic button operation in menu mode. Note that there
are three menu modes, No signal menu mode, video menu mode and PC menu mode. When the MENU button is pressed,
the projector enters one of these modes by judging the input signal being received.
I Menu Transition Diagram in No signal Menu Mode
This is displayed if there is no signal from the selected input terminal.
Main menu in No signal Menu Mode
Press 5/∞ to select an item.
Menu
Options
Language
Information
5
Options
Language
Information
∞
Menu
Options
Language
Information
I Quick Reference Guide for No signal Menu Mode
Main Menu in No signal Menu Mode
Options
Right Left rev.:
Top Bottom inv.:
RS-232C [bps]:
Sleep time [min:]
PC2 (BNC):
Language
Japanese / English* / German / Spanish / Italian / French
Information
Input:
Switcher:
Lamp time:
3 or ENTER
Right Left rev.
Top Bottom inv.
RS-232C
ESCAPE
Sleep time
PC2 (BNC)
5 ∞
Menu
English
Deutsch
Español
Italiano
Français
5
∞
PC1
Input
Switcher CH.0
Lamp time 123 h
OFF* / ON (Select for upside-down hanging on the ceiling.)
OFF* / ON (Select for upside-down hanging on the ceiling.)
Selectable baud rate (transmission speed). 9600 / 19200*
Selectable sleep times. If no-signal condition continues for the period of selected time (Unit:
Minutes), the projector enters the stand-by mode. 15 / 30 / 60 / OFF*
RGB* or YP P . Set to RGB when a computer device with analog RGB, V, H/Cs signals is
B R
connected to the PC2 terminals. Set to YP
or DTV-format signals (Y, P
Language for on-screen display.
Shows the terminal name selected by the VIDEO or PC button. (Y/C, VIDEO, or PC2)
Has no meaning. This display currently has no meaning. ("CH.0" is usually displayed to indicate
that it is not being used.)
Accumulated used hours of the light-source lamp.
Submenus in No signal Menu Mode
Press 5/∞ to select an item.
Press 2/3 to set the value.
Options
Right Left rev.
Top Bottom inv.
RS-232C [bps]
Sleep time [min]
PC2 (BNC)
Press 5/∞ to select an item.
Language
3 or
English
ENTER
Deutsch
Español
ESCAPE
Italiano
Français
P when a device with component signals (Y, B-Y, R-Y)
B R
, P ) are connected to the PC2 terminals.
B R
OFF ON
OFF ON
9600 19200
15 30 60 OFF
RGB YP P
B R
37