Eco ETS Series Manual page 9

Procedure
10. Chose set up procedure (Teach) and confirm with OK.
11. Start the set up procedure (Teach) and confirm with OK.
12. The set up procedure starts automatically after 10 seconds (or directyl by moving the joystick
, without OK). The drive beeps during the set up process.
Following learning trip is made:
 Inverse: First, the closed position is searched at creep spped.
 Creep spped in opening direction
 Creep speed in closing direction
13. The following message is displayed at the end of the learning trip:
14. Display should now show the following:
E11 shows that the set up process is not yet finished.
15. Use the opening command to open and close the door leaf. This opens and closes at normal
speed (withouth obstacle detection).
Note: Door leaf must not be obstructed.
Display should now show the following: The set up process is now complete.
Note:
A new set up process is necessary if:
 the spring tension was changed
 the leaf weight was changed
 the linkage type was changed
 the opening angle Ao was changed
 the Teach was obstructed before 20° opening angle
 the axis distance (dAxis) was changed
 the parameter inverse was changed.
Teach
Teach
ok?
Teach1
x E10
Teach2
x E10
Done !
x E11
>##<
E11
>##<
E11
9