Eco ETS Series Manual page 27

SETTINGS
MULTI-LEAF SYSTEMS
Parameter Description
DubleD Roll for closing sequence control (Master/Slave) and Sluice-side (A/B)
AoSeq Opening sequence delay angle (slave)
(only visible if DoubleD is active)
AcSeq Closing sequence delay angle (Master)
(only visible if DoubleD is active)
InterL Sluice
ILAuto Sluice operating mode AUTOMAT
(only visible if InterL is active)
ILExit Sluice operation mode EXIT
(only visible if InterL is active)
ILNigt Sluice operating mode NIGHT
(only visible if InterL is active)
ILType Safety: Two doors work as a sluice (in all operating modes). The second door only opens if the
first one is closed. Has to be set on both doors.
Spital: Automatic sequence -> When an opening command is given, the door that receives
the the opening command is opened. After this door is closed again, the second door
opens automatically.
NL: The second dor only opens if the first one is closed or when the override time runs out.
TOverd Only visible in ILType NL
When the override time runs out, the sluice function is cancelled. As soon as both doors are
closed, the sluice function is switched on again.
RdrOEI OFF: Radar OEO/OEI switches normally, door closes when both are inactive.
ON: With OEO the (OEI) radar inside the sluice is masked out, so that it won't hold oben
the door in tight sluices.
ILCdRc Acitve: The opening commands are buffered and executed when the second door is closed.
Inactive: The opening commands are only accepted and executed as soon as the second door
is closed.
(DOUBLE DOOR)
Setting range
OFF
MastrA
SlaveA
MastrB
SlaveB
0...110 °
0...110 °
OFF
SideA
SideB
Inacti
Active
Inacti
Active
Inacti
Active
Safety
Spital
NL
OFF
1...60s
OFF
ON
Active
Inacti
Default
OFF
20 °
20 °
OFF
Active
Active
Active
Safety
OFF
OFF
Active
27