Eco ETS Series Manual page 31

Operating
No. Description Cause
E10 01 Fullteach Parameter Ao, Rod, Invers
required or dAxis changed
02 Minimum opening angle
not reached
E11 01 Halfteach Parameter Vo changed
required
(Opening)
02 Halfteach Parameter Vc or FSlam chan-
required ged
(Closing)
E14 01 Locking / Door leaf stucks in the locking /
Electronic lock electronic lock.
02 Inverse-operation has no
locking or locking force Fch is
not adjusted
E15 01 Obstacle in ope- Too many obstacles encounte-
ning direction red in a row
02 Obstacle in
closing direction
E16 01 Temperature Temperature on output range
has reached 81° C
02 Temperature on output range
has reached 91° C
Solution
Proceed Teach
Check locking / electronic lock
Proceed complete, unobstructed
opening cycle
Proceed complete, unobstructed
closing cycle
Check function of locking / electronic lock
Adjust/increase locking force
 Check system
 Remove obstacle
 Move door leaf to target position
Observe the limits of use.
Testing time Reaction
When changing H
the drive configu-
ration
During the Teach
When changing W
the ride parame-
ters
When opening H
from close-
position
At the end of the W
Teach
Permanently H, A
Restart after
60 s
Permanently A
Drive running
reduced
A
Drive stands
still
31