Drive Parameters - Eco ETS Series Manual

ECO ETS – Assembly Buddy
SETTINGS

DRIVE PARAMETERS

Parameter Description
Vo Velocity open (velocity open)
Vc Velocity close (velocity close)
TOEx Hold open time opening element inside / outside (time hold opening element inside/outside)
TKey Hold open time Key (time hold opening element Key)
TDelay Start-up delay (time delay lock)
FDelay Relief force when unlocking (force delay), only works if TDelay is >0.
TLock Door hold-up time (time press close)
FLock Pressing force while locking (force lock), only works when TLock is >0.
FSlam Slam function (force slam)
FWind Obstacle detection optimised for external doors. (force wind)
Fo Opening force (force open)
Fc Closing force (force close)
Foh Hold open force (force open hold)
Fch Locking force (force close hold)
Ao Opening angle of the door (angle open)
If the opening angle is changed in the OPEN mode, the operating mode must be changed to
HAND to close the door.
Rod Linkage types (Rod)
Invers Inverse-Application: In case of power failure / error, the door leaf is opened from any position
by spring force (if not locked). Position of the motor plug is reversed to the standard drive. The
electric lock / holding magnet must be connected in reverse to the standard drive (see wiring
diagram E4-0141-713).
dAxis Distance between door hinge rotation axis and the drives mounting level (distance Axis). dAxis
is a guide value. Depending on the mounting situation, dAxis must be adapted accordingly.
Fos Limitation of the opening force.
Must not be increased in Germany!
* Note: A new set-up process (Teach) is required.
26
automatically sets FLock and FDelay if they are 0
(PARAMETER)
Setting range
0...14 (5...50 °/s)
0...14 (5...0 °/s)
0...60 s
0...180 s
0,0...4,0 s
0,0...7,0 A
0,0...4,0 s
0,0...7,0 A
0...10
OFF
OPEN
CLOSE
BOTH
0...9
0...9
0...9
0,0...3,5 A
20...(190 °) Rod dep.
Standard arm pressing STD - PH
Sliding rail pulling SLI - PL
Sliding rail pushing SLI - PH
Leaf mounting pushing WIN - PH
Without linkage pushing DIR - PH
Without linkage pulling DIR - PL
OFF
ON
-8...+25 cm
Rod dep.
5...14 A
Default
6
4
3 s
5 s
0,2 s
OFF
0,5 s
2,0 A
OFF
OFF
4
4
0
0
95 °
*
STD - PH
*
OFF
*
0 / +8 cm
Rod dep.
*
5 A