Eco ETS Series Manual page 25

Product Connections
Control panel Bedix ETS
6
7
Note: Always use a seperate cable for the Bedix and connect all wires. Double if necessary
Radio transmitter Transmitter
and receiver
blue
for rocker large surface button
(GFT)
brown
Teach in transmitter / receiver:
1. Set the receiver to operating mode 3:
Push programming button 3 x approx. 1 sec. until the LED fl ashes as follows: 3 x short - break - 3 x short
2. Keep the transmitter / button (GFT) pressed until the LED on the receiver shows 4 sec. continuous light,
then the LED fl ashes again. Now release the button (GFT) (this transmitter is now taught-in).
3. Same procedure for other transmitters / buttons as above (pos. 2).
4. Press the programming button on the receiver once = operating mode, LED off.
5. Test the function on the GFT, blue LED must be lit on the ETS.
Light up = opening command.
Note: Connection for comparable opening buttons is identical.
Key switch Key switch ETS-Functions
ST-02-UP (HPZ)
At switch position 0 (standard)
"automatic (all control elements)
COM
is active. At switch position 1,
one of the following functions
NO
can be selected.
NC
Bedix Cable specification
4 shielded cable U72M or
3 EIB-Y(St)Y 2x2x0,8 mm, twisted
wires
GFT Receiver
black (COM) + (1)
blue (N.O) - (2)
COM (3)
N.O (5)
Night Hand
(Key) (manual)
26 26
23 24
22 22
Illustration
ETS
1 (24 V)
3 (GND)
3 (GND)
2 (KEY)
One way
(only OEI)
26
25
22
25