Eco ETS Series Manual page 33

System
No. Description Cause
E50 01...99 System error Unexpected hard- or soft-
ware event
E51 01...99 System error Unexpected hard- or soft-
ware event
E52 01...99 System error Unexpected hard- or soft-
ware event
Options
No. Description Cause
E60 00 Relaisprint 0 Option print has been removed,
redirected or is defective
10 Relaisprint 1
20 Radio print
30 Fire protection
print
Closing sequence control / Sluice
No. Description Cause
E70 xx CAN-Bus- CAN-Address xx existing
configuration two times.
E71 01 CAN-Connection No CAN-Connection
Solution
 Switch on/ off drive
 Perform factory reset
 Perform software update
 Contact manufacturer
 Switch on/ off drive
 Perform factory reset
 Perform software update
 Contact manufacturer
 Switch on/ off drive
 Perform factory reset
 Perform software update
 Contact manufacturer
Solution
 Check if option exists
 Falls If defective:
Replace or remove from configuration
 Note:
 Deleting the error 60
see mounting instruction ECO ETS

(Chapter 13.7.1)
Solution
Define closing sequence or sluice roll
correctly.
 Plug in, control or replace CAN-Cable
 Control if all CAN-Participants are swit-
ched on
Testing time Reaction
Permanetly W or F or H
Permanetly W or F or H
Permanetly W or F or H
Testing time Reaction
Permanently W
W
W
A
Testing time Reaction
Permanently W
Permanently W
33