Error Codes - Eco ETS Series Manual

ECO ETS – Assembly Buddy

ERROR CODES

MISBEHAVIOUR WITH ERROR-NO
Drive
No. Description
E1 03 Encoder
04
05
06
07
08
09
10
01 Motor power
E2
02
E3 01 Damping
02
E4 01 Reference
switch
02
03
E5 00 Power limitation
30
(DISPLAY)
Cause Solution
Canal A + B lost  Check encoder connection
 Check motor cable
Short of A + B
 Rotation direction of the motor doesn't
Disruptions
 Door is blocked
Motor wire plugged wrong
 Check if the Jumper is on X106
No canal A
No canal B
No canal A + B
Short of A + B
Power too high  Check motor cable
 Check if the Jumper is on X106
 Power too low
 Jumper missing
Test failed once  Set drive to operating mode HAND and
 Test failed twice
 Damping defective or opening
 If not, replace hardware
beyond heart curve peak
 If yes, check/correct friction of the door
Detected in open-position  Check the connection and switching point
Not detected in closed-position
 Reference switch must be actuated in
Not detected in open-position
 Overload of the control  Check/correct friction of the door leaf and
 Maximum power is limited
correspond with the linkage.
cauiously try if the door closes with
damping.
leaf and the closing spring preload.
of the refernece switch.
closed position (switching contact open).
the closing spring preload.
Testing time Reaction
While driving H
Before starting
Before starting H
Before closing, W
after starting up
Drive conti-
and then every
nues running,
24 hours.
buzzer active.
Open position F
Before the first set A
up ride
Permanently A