Chapter 3 Wheel Angle Sensor Installation; Assemble The Wheel Angle Sensor (Was); Install The Was - Raven SC1 Installation Manual

CHAPTER
3

ASSEMBLE THE WHEEL ANGLE SENSOR (WAS)

FIGURE 1. WAS
Base-End
of Sensor
1. Install the M10 universal ball mounts (P/N 103-0001-029) and M10 jam nuts on both ends of the linear WAS (P/
N 416-0001-052).
2. Leave the nuts and ball mounts loose until the sensor is installed later in the procedure.

INSTALL THE WAS

1. Park the machine on a level surface with the wheels pointing to the left.
2. Install the WAS base end mounting brackets on the right steering cylinder clevis using the provided M8 flat-
head machine screws, flat washers, lock washers, and nuts.
FIGURE 2. WAS Base End Mounting Brackets Installed
016-5032-127 Rev. C
W HEEL ANGLE SENSOR
C H A P T E R 3
INSTALLATION
Rod-End of
Sensor
9