Table of Contents
Advertisement
The correct temperature
Setting the temperature
The two sensors next to the display are
used for setting the temperature.
Touch this sensor to lower the
temperature.
Touch this sensor to increase the
temperature.
While the temperature is being set, the
temperature value will flash.
The following information appears in the
display when the sensors are touched:
– When first tapped: The last preset
temperature flashes.
– Each subsequent touch of the
sensor: The temperature is adjusted
in 1 °C steps.
– Leaving the finger on the sensor
changes the temperature
continuously.
Approximately 5 seconds after the last
time a sensor has been touched, the
display automatically reverts to showing
the current temperature inside the
appliance.
22
Useful tip: If you have adjusted the
temperature, wait for approx. 6 hours
if the appliance is not very full and for
approx. 24 hours if the appliance is
full before checking the temperature
display. It will take this long for an
accurate reading to be given. If, after
this time, the temperature is still too
high or too low, adjust it again.
Temperature range
The temperature can be adjusted from
2 °C to 9 °C.
Advertisement
Table of Contents
