Table of Contents
Advertisement
The correct temperature
Temperature display
In normal operation, the temperature
display shows the current average
refrigerator section temperature and
the maximum freezer section tem-
perature.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature on the display.
Setting the temperature in the
refrigerator/freezer sections
Touch the OK sensor control on the
control panel.
will appear in the display (refrigerator
section is selected).
Use the and sensor controls to
change the selected temperature
zone if required.
Touch OK.
Use the and sensor controls to
change the temperature.
Touch OK.
The temperature display will then
change back to the current temperature
in the relevant temperature zone.
Possible temperature settings
- Refrigerator section: 2 to 9 °C
- Freezer section: -15 to -26 °C
44
If you change the temperature set-
ting:
check the temperature display after a
few hours. It will take this long for the
appliance to give an accurate read-
ing.
- Wait for approx. 6 hours if the refri-
geration appliance is not very full
- Wait for approx. 24 hours if the refri-
geration appliance is full
If, after this time, the temperature is still
too high or too low:
Adjust the temperature again.
Advertisement
Table of Contents
