The correct temperature
Temperature display
In normal operation, the upper tem-
perature display shows the current
average refrigerator section tem-
perature and the lower temperature
display shows the highest freezer
section temperature currently being
recorded within the refrigeration appli-
ance.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature on the display.
30
Setting the temperature
Use the two and sensor buttons
for the relevant section to set the
temperature higher or lower.
The following changes will be seen on
the display when the sensor buttons are
touched:
- With the first touch: The last temper-
ature set flashes.
- Each subsequent touch: The temper-
ature changes in 1° increments.
- Keeping your finger on the sensor
button: The temperature changes
continuously.
Approximately 5 seconds after the last
time a sensor button was touched, the
actual temperature inside the appliance
will automatically be displayed.
Temperature range
- The temperature in the refrigerator
section can be set between 36°F
(2°C) and 45°F (7°C).
- The temperature in the freezer sec-
tion can be set between 7°F (-14°C)
and -17°F (-27°C).
Tip: If you have adjusted the tempera-
ture, wait for approx. 6 hours if the
machine is not very full and for ap-
prox. 24 hours if the machine is full
before checking the temperature dis-
play. It will take this long for an accurate
reading to be given.
If, after this time, the temperature is
still too high or too low, adjust it
again.