Dura Trel 11137 Instructions

Bench mounting kit

MATERIAL LIST

2 – #4TBCK-05500

2 – #4TBCK-05750

8 – #7HDWR-14225

16 - #7HDWR-08125

16 – #7HDWR-14WSH ¼" Flat Washers

8 – #7HDWR-14NUT ¼" Nylock Nuts

1 – Bench Mounting Instructions

Drill with ¼" Bit and #2

Phillips Bit

2 – 7/16" Wrenches or Sockets

Set assembled bench in desired location. Slide the two 5 ½" brackets under back legs of bench and

the two angled brackets under the front legs. With 1 ¼" screws fasten brackets to pier or deck.

With bench setting on brackets, use the ¼" drill bit to drill holes through bench legs, using the

predrilled holes in brackets as your guide. Fasten bench to brackets using 2 ¼" bolts, washers and

nylock nuts.

If you encounter missing or defective parts, please contact manufacturer direct at

Dura-Trel, Inc. ~ PO Box 122, Sheboygan Falls, WI 53085 ~ Toll Free 877-258-6020

5 ½" Back Leg Brackets

5 ¾" Angled Front Leg Brackets

¼ x 2 ¼" Bolts

#8 x 1 ¼" Screws

toll free # below.

#11137

ENCH

OUNTING

INSTRUCTIONS

Table of Contents

Do you have a question about the 11137 and is the answer not in the manual?

Page 1 #11137 ENCH OUNTING INSTRUCTIONS MATERIAL LIST 2 – #4TBCK-05500 5 ½" Back Leg Brackets 2 – #4TBCK-05750 5 ¾" Angled Front Leg Brackets 8 – #7HDWR-14225 ¼ x 2 ¼” Bolts 16 - #7HDWR-08125 #8 x 1 ¼” Screws 16 – #7HDWR-14WSH ¼” Flat Washers 8 –...
Page 2 PACKING LIST #11137 BENCH MOUNTING KIT PARTS CONTAINED: QTY. PART NO. PART DESCRIPTION 4TBCK-05750 W 5.75” ANGLED BRACKETS 4TBCK-05500 W 5.5” BRACKETS 7HDWR-14225 ¼ x 2 ¼” BOLTS 7HDWR-08125 #8 x 1 ¼” SCREWS 7HDWR-14WSH ¼” FLAT WASHERS 7HDWR-14NUT ¼” NYLOCK NUTS...