Power Requirements; Operating Rate; Operating Conditions; Tape - 3M -Matic 800rf Instructions And Parts List

4-SPECIFICATIONS

4.1 Power Requirements

Electrical: 115 Volt, 60Hz, 3.8 A (440 watts)
(*Note: Electric Information may not relect machine electrical settings/requirements in your area)
The machine is equipped with a 2.4m [8 foot] standard neoprene covered power cord and a grounded plug.
Contact your 3M Representative for power requirements not listed above.
Pneumatic – 6 bar gauge pressure [87 PSIG] @ 21 C, 1.01 bar [3.75 SCFM] at 15 boxes per minute A
pressure regulator is included
Machine requires 75 – 140 PSIG
[5.2 – 9.5 BAR] 7.0 SCFM
[11.89 m
The optimum operating set point on the gauge is 95 – 100 PSIG.)

4.2 Operating Rate

Box drive belt speed is approximately 0.5 m/s [100 feet per minute].
Infeed conveyor speed: 21m/min
Production = 600 boxes/hour (average)

4.3 Operating Conditions

Use in dry, relatively clean environments at 4.4
Note: Machine should not be washed or subjected to conditions causing moisture condensation on
components.

4.4 Tape

pressure-sensitive fi lm box sealing tapes.
®
Scotch

4.5 Tape Width

36mm [1 1/2 inch] minimum to 50mm [2 inch] maximum
800rf Case Sealer. This model offers 3-inch wide upper and lower AccuGlide™ 3 Taping
Heads for tape widths from 2 inches [48 millimeters] to 3 inches [72 millimeters].
800rf-NA
/h 21 C, 101 kPa] at the regulator, maximum at maximum cycle rate.
3 o
WARNING
• To reduce the risk associated with fi re
and explosion hazards:
− Do not operate this equipment in poten-
tially fl ammable or explosive environments.
208/240V, 60Hz, 3Ph, 4.25A (620W)
o C to 48.9 o C [40 o F to 120
12
o F] with clean, dry boxes.
2012 March