Advertisement
Available languages
Available languages
INSTALLATION
With the key in the off position:
• Connect the AXVI-6523 harness into the interface, and then to the harness in the vehicle.
Note: If using the AXSWC, connect it after you initialize and test the AXVI-6523, with the key
in the off position.
PROGRAMMING
Attention! If the interface loses power for any reason, the following steps will need to be
performed again. Also, if installing an AXSWC connect it after you initialize and test the interface/
radio, with the key in the off position.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key to the off position, and then to the accessory position. Test all functions of the
installation for proper operation, before reassembling the dash.
REV. 10/23/2019 INSTAXVI-6523
3
Advertisement
