Advertisement
TOYOTA
Picture 8B
12.
Install a black T-tap to connector J50 pin 1,
blue. J50 is located at the back of the cargo
light switch. Then connect the blue wire
from DRL harness to the t-tap (pictures 9,
9A and 8B).
Picture 9: DRL blue wire to connector J50, pin1 (blue wire)
Picture 9A
13.
Secure ground (black) wire to bolt by the
kick panel (picture 10)
Southeast Toyota Distributors, LLC
TUNDRA
14.
Secure relay, fuse and any excess wire
from t-taps to factory wire harness, next to
driver box (picture 11)
15. Use an empty switch knock out on left panel,
(left to the cargo light switch) and mount
switch into switch knock out (picture 12).
Page 5 of 16
Billet Grille w/LED DRL
Picture 10
Picture 11
Advertisement
