Advertisement
TOYOTA
grommet left to the emergency brake
(picture 5)
Picture 5
7.
Route the wire harness to reach the left
area of the steering wheel
8.
Push the pins into the connector supplied in
kit. The plastic connects have a mark with a
positive (+) and a negative (-) symbol. Push
the red wires into the "+" symbol and the
black wires into the "-" symbol (picture 6)
Picture 6
9.
Connect the driver box to the wires pushed
into the connectors on step 8 (make sure
wire colors are aligned: black with black and
red with red).
Southeast Toyota Distributors, LLC
TUNDRA
10.
Using a 14" wire tie, secure the driver box to
the factory harness by the kick panel
(picture 7)
11.
Install a black T-tap to connector J130 pin 8,
light green wire. J130 is located on the back
of the power mirror control switch. Then
connect the red wire from DRL harness to
the t-tap (pictures 8, 8A and 8B).
Picture 8: DRL red wire to connector J130 (light green wire)
Page 4 of 16
Billet Grille w/LED DRL
Picture 7
Picture 8A
Advertisement
