Advertisement
TOYOTA
33.
Reinstall the factory chrome grille shell (with
the brackets installed) on the vehicle, make
sure the brackets slide under the black
plastic arms on the core support (picture 27)
and that the holes in the u-nut and bracket
line up with the hole in the plastic bracket on
the core support.
Picture 27
34.
Reach down behind the factory grille and
locate the brackets that you installed on
step 7 and insert the factory plastic fastener
through the hole in the bracket and into the
same hole in the vehicle it was removed
from (picture 28). Make sure the fastener is
fully inserted and secure.
Picture 28
35.
Take the two bottom extension brackets and
install u-nuts onto the small ends aligning
with the holes in the brackets and orient it
as shown (picture 29).
Southeast Toyota Distributors, LLC
TUNDRA
36.
Install two u-nuts onto the two flange
brackets aligning the holes in the u-nuts
with the holes in the flange brackets and
orient it as shown (picture 30).
37.
Take the two flange brackets (with the u-
nuts installed) and attach them onto the
large ends of the bottom extension brackets
with one #8X3/4" screw and one 1" black
fender washer. You will only need to screw
the threads in a couple of turns as you want
the flange brackets to have some space
between them and the bottom extension
bracket. You will have two assembled
bottom extension brackets (picture 31).
Page 10 of 16
Billet Grille w/LED DRL
Picture 29
Picture 30
Advertisement
