Advertisement
TOYOTA
21.
Place the factory grille face down on a clean
soft surface (take special care to protect the
chrome factory shell). On the back of the
grille assembly use a Phillips screwdriver to
remove two Phillips screws from each side
of the factory grille: 4 total (picture 16)
Picture 16
22.
Now remove the black plastic grille insert
from the factory grille shell by unlatching
thirteen plastic latches around the grille with
a flat screwdriver and remove the black
plastic grille insert (picture 17)
23.
With a pair of pliers break off all thirteen
clips from chrome plastic frame, this will
allow your billet grille to sit flush with the
chrome frame during installation (picture 18)
Southeast Toyota Distributors, LLC
TUNDRA
17
24.
Use a nylon fastener tool to remove two
plastic fasteners located just below the
inside bottom corner of each headlamp
(picture 19). Save these fasteners, as you
will use them later in the installation.
25.
Remove the factory Toyota logo from the
factory grille by pressing the tabs on the
back of the logo inward while pulling the
logo forward
ENGINE COMPARTMENT
26.
Run DRL's wire harness from the large
vehicle harness grommet on the left side
(step 2) through the driver side, towards the
front of the vehicle. Use wire ties to secure
harness (picture 20, 20A and 20B)
Page 7 of 16
Billet Grille w/LED DRL
Picture 18
Picture 19
Advertisement
