Advertisement
2 | Keysight | E4982A LCR Meter 1 MHz to 300 MHz/500 MHz/1 GHz/3 GHz - Coniguration Guide
Ordering guide
The following steps will guide you through coniguring your E4982A.
Standard furnished item
Description
Test head with 1m test cable
Installation Guide
I/O Library CD-Rom
Power Cable
Certiication of Calibration
Note: The following are not furnished: Calibration kit, Test Fixture Stand, 3.5 mm-to-7 mm Adapter, Keyboard and Mouse.
Refer to Accessory Option and Available Accessories for the selection of these items.
Step 1. Choose Frequency Option (Mandatory)
Description
1 MHz – 300 MHz
1 MHz – 500 MHz
1 MHz - 1 GHz
1 MHz - 3 GHz
Step 2. Choose accessory option for integrating into component handler system
(If not required, go to Step 3.)
Description
Working standard set
Test head extension
cable set
16195B calibration kit
Note: Refer to Upgrade for retroit information on the above options.
Additional information
See Accessory option for cable extension
Option No.
Requires
E4982A-030
E4982A-050
E4982A-100
E4982A-300
Option No.
Requires
E4982A-004
None
E4982A-020
None
E4982A-710, -720
E4982A-700
Not Compatible
Additional Information
Not Compatible
Additional Information
None
Required when performing calibration at DUT
contacts of component handler or test ixture.
Includes Shorting Bars and 51.0 Ω Chip Resistors
(SMD size: 1.0 x 0.5 mm, 1.6 x 0.8 mm, 2.0 x 1.2
mm, 3.2 x 1.6 mm)
None
Coaxial cable set for extending the test head
cable to 2 m from standard 1 m. Required when
2 m test head cables are needed for installation.
None
Recommended for system calibration and
tests. Usable for multiple E4982As. Required to
perform calibration at 7 mm connector plane of
3.5 mm-to-7 mm adapter attached to 3.5 mm
test port connector on test head. Includes OPEN,
SHORT, 50 Ω LOAD, LOW-LOSS CAPACITOR
standards and carrying case.
Advertisement
