ICW LTU-W3-A2 Installation

ICWUSA.com, Inc.
IF MOUNTING TO THE
ULTRA WALL TRACK

ATTACH SLIDER TO ULTRA TRACK

Insert Slider
into Wall Track
as shown
at left and
replace the
small socket
head cap
screw and
plastic cover.
IF MOUNTING TO THE WALL

ATTACH WALL PLATE TO WALL

LAPTOP TRAY ARM INSTALLATION

MOUNT ULTRA TRACK TO WALL

Locate the wall stud and mark the top
hole of the Wall Track, drill 11/64 pilot
hole and insert #14 screw and tighten
slightly. Use a level, mark the lower
holes, drill pilot holes and then insert the
#14 screws.
NOTE: #14 Wood screws are supplied with unit. If
installing into metal studs, you will need to replace
these with proper metal stud fasteners
Once you have adjusted the
slider to the desired height,
tighten down the Track
Slider using the handle on
the slider as shown.
Once tight, make sure the
handle is positioned so that
it is pointing down as far
as possible. Pull and turn
handle to position.
If you have any questions, please call 1-800-558-4435
Locate the stud and mark the top
hole, drill 11/64 pilot hole and insert
#14 screw and tighten slightly. Using
a level, mark the lower hole and drill
pilot hole, insert #14 screw and, with
the unit level, tighten both screws.
NOTE: ICW supplies #14 wood
screws. If installing onto metal studs,
you will need to replace with proper
metal stud fasteners.
LAPTOP TRAY ARM INSTALLATION - rev 09/27/2011 mf
LTU-W3-A2
small socket
screw in the
plastic cover.
Remove
head cap
top middle
of the Wall
Track.
Remove