Table of Contents
Advertisement
In case of a car without a navigation system, start
the work from step 21. In case of a car with a naviga-
tion system, start the work from step 32.
<Car without a navigation system>
21. Cut the ribs of the glove box.
•
Remove any burr.
22. Remove the two screws from the adapter unit.
23. Install the two adapter brackets B with the two
removed screws on the adapter unit.
•
Install the two adapter brackets B at the
correct positions in the correct orientation.
24. Align the centers of the cut rib positions with
the centers of the adapter bracket B holes and
set the adapter unit.
25. Use a felt-tip pen and mark at two locations at
the adapter bracket B holes.
24 / 32
UTILITY KNIFE
GLOVE BOX
GLOVE
BOX
ADAPTER
BRACKETS B (2)
08B28-SMR-6001-96
Cut on the extension of the rib.
30 mm
45 mm
SCREW
(Reused.)
ADAPTER
UNIT
ADAPTER
UNIT
ADAPTER
UNIT
FELT-TIP PEN
RIB
Cut off.
6706061Y
ADAPTER
BRACKETS B (2)
6706050Y
MARK
MARK
Mark the locations
where the adapter
bracket B hole centers
coincide with the
former rib centers.
6706070Y
Advertisement
Table of Contents
