Table of Contents
Advertisement
46. Mark the two dimension positions with a felt-tip
pen on the front console.
47. Prick the two marked positions with a pushpin.
Use an electric drill to drill holes with 3 mm
diameter at the two marked positions, and then
widen the holes with a 15 mm hole saw.
48. Join the two 15 mm holes by cutting as shown.
•
Remove any burr.
MARK
15 mm From
the rounding
end.
UTILITY KNIFE
FRONT
CONSOLE
08B28-SMR-6001-96
FRONT CONSOLE
10 mm
From the
rounding
end.
15 mm
FRONT CONSOLE
ELECTRIC DRILL
(3 mm drill bit)
PUSHPIN
Mark made in
step 46.
FELT-TIP PEN
6706410Y
HOLE SAW
(15 mm)
FRONT
CONSOLE
6706420Y
17 / 32
Advertisement
Table of Contents
