Table of Contents
Advertisement
30. Clean the urethane attachment surface with
contact cleaner. Attach one piece of urethane
to the adapter unit.
31. Clean the cushion tape attachment surface
with contact cleaner. Route the adapter unit
harness and the iPod
secure them with three cushion tapes to the
glove box. (Perform the work from step 37.)
<Car with a navigation system>
32. Mark the two dimension positions with a felt-tip
pen on the glove box.
33. Prick the two marked positions with a pushpin.
Use an electric drill to drill holes with 3 mm
diameter at the two marked positions, and then
widen the holes with 6 mm drill bits.
•
Remove any burr.
®
iPod
is a trademark of Apple
Computer, Inc., registered in the U.S.
and other countries.
®
harness as shown and
08B28-SMR-6001-96
GLOVE BOX
CUSHION
TAPES (3)
URETHANE
FELT-TIP PEN
GLOVE BOX
MARKS (2)
GLOVE BOX
ADAPTER
UNIT
®
iPod
HARNESS
HARNESS
GLOVE BOX
35 mm
45 mm
MARK
PUSHPIN
ELECTRIC
DRILL
(3 mm
6 mm drill bit)
Marks made in step 32.
6706330Y
6706261Y
6706271Y
13 / 32
Advertisement
Table of Contents
