Performing A Factory Reset (Reset To Factory Defaults) - Omicron Lab OTMC 100 Quick Start Manual

Hide thumbs Also See for OTMC 100:

Table of Contents

LED flashes green

The password dialog is

displayed when accessing

the web interface of

OTMC 100. You do not

know the password.

6.1

Performing a factory reset (reset to factory defaults)

The pushbutton can be accessed after unscrewing the water-tight membrane vent. Use a pointed tool

such as a ball-pen to press the pushbutton (see figure on page 18).

NOTICE

Ingressing water may cause equipment damage.

► Do not forget to reinsert the membrane vent in order to restore watertightness.

► Tighten the membrane vent with a tightening torque of 0.6 to 0.8 Nm.

1. Press the pushbutton and keep it pressed.

2. The LED goes off.

3. After approx. 5 s, the LED lights up orange. Keep the button pressed and wait until the LED lights

up red.

4. Release the pushbutton.

5. After approx. 15 s the LED changes to green to indicate operational readiness.

The device now has the factory default configuration settings. Password protection is disabled and the

password is reset to the factory default password timeserver.

OMICRON

OTMC 100 is in the recovery mode, waiting for new software. Refer to

chapter "Operating OTMC 100" of the OTMC 100 Series User Manual.

Perform a factory reset directly on the OTMC 100 device (→ see

"Performing a factory reset (reset to factory defaults)" below).

Performing a factory reset disables password protection and resets the

currently defined password to the factory default password timeserver.

Troubleshooting

Table of Contents