Table of Contents
Advertisement
OTMC 100 Quick Start Guide
3.3
Mounting instructions
There are two possible ways for mounting OTMC 100.
Mast mounting using the delivered mast mounting
kit (see
Mounting instructions for mast
mounting
on page 10).
3.3.1 Mounting instructions for mast mounting
The mounting kit delivered with OTMC 100 contains the following parts:
•
1 mast clamp consisting of 2 clamping jaws and 4 fastening screws M6 x 110 with lock washers
•
2 clamping blocks and 4 fastening screws M6 x 16 with lock washers
•
1 connection pipe 20 x 300 mm
Proceed as follows:
Assemble the mast clamp and attach it to the mast as
shown in the figure.
The mast clamp is suitable for mast diameters of 25
to 70 mm.
Use a tightening torque of 5 Nm for the fastening
screws of the clamping block (1). The tightening
torque for the fastening screws of the mast clamp (2)
depends on the material and diameter of the mast.
10
Temporary mounting using the 1/4" BSW
(British Standard Whitworth) thread for
mounting on a stand, for example.
1
2
OMICRON
Advertisement
Table of Contents
