Table of Contents
Advertisement
4. OMICRON Device Link will automatically find and display your OTMC 100.
The vertical bar on the left displays the device status:
•
Green bar: The device is online and ready for operation.
•
Gray bar: The device is offline. Connect your OTMC 100 to the Ethernet network. If the
network is not able to supply your OTMC 100 via PoE (Power over Ethernet), use a PoE
injector to supply your OTMC 100 with power.
•
Red bar: The device is online but not accessible due to incorrect IP configuration.
OTMC 100 is usually configured to obtain the IP address automatically. However, it is also
possible to assign a static IP address to your OTMC 100. In this case, the following behavior
applies:
When accessing OTMC 100 via Ethernet, OMICRON Device Link will find your OTMC 100, but
display a red bar to indicate that the device cannot be accessed.
► Click the OTMC 100 entry and select Configure IP.
OMICRON Device Link will then display an IP configuration page. In this page, select Use the
following IP address and enter the IP address of your OTMC 100, or enter an IP address of
your choice to assign a new IP adress to your OTMC 100. Click the Subnet mask field to
automatically fill a subnet mask and then click Apply to connect to your OTMC 100.
Or
► Click the Add device button and enter the IP address assigned to your OTMC 100.
OMICRON
Accessing OTMC 100 from a Computer
15
Advertisement
Table of Contents
