Table of Contents
Advertisement
OTMC 100 Quick Start Guide
5
Accessing OTMC 100 from a Computer
OTMC 100 automatically powers up after supply voltage is provided via Ethernet (PoE). The LED
lights up green when the device is ready for operation.
After that, a network IP address is assigned automatically in order to connect the device to the
network. If a DHCP server is available in the network, the IP address is assigned by the DHCP server.
If not, OTMC 100 automatically selects and assigns a link-local IPv4 and IPv6 address by itself.
5.1
System requirements
Your computer must fulfill the following requirements to access the OTMC 100 web interface:
•
Network port configured for operation in the network OTMC 100 is connected to.
•
OMICRON Device Link installed (→ see
•
Web browser installed (Microsoft Edge, Mozilla Firefox 20 or higher, or Google Chrome version 31
or higher).
If you are accessing OTMC 100 from a Mac or Linux operating system supporting zeroconf,
you can access the web interface of OTMC 100 by entering http://<hostname>.local to the
address bar of your web browser. The default hostname is the device serial number. The
serial number is available on the type plate on the bottom side of OTMC 100 (labeled
"SerNo").
5.2
Accessing the OTMC 100 web interface
Proceed as follows to access the OTMC 100 web interface:
1. Connect your computer to the network.
2. If necessary, install OMICRON Device Link on your computer.
► Exit all other major programs running on your computer.
► Insert the CD ROM into your computer's CD ROM drive and click Install Device Link on the
start page. Should the start page not be displayed automatically a few seconds after the CD
has been inserted into the CD ROM drive, change to the Windows Explorer and double-click
autorun.exe on the CD ROM.
► Follow the instructions displayed on the screen to install the software.
3. Launch OMICRON Device Link.
14
Accessing the OTMC 100 web interface
on page 14).
OMICRON
Advertisement
Table of Contents
