Bosch FLEXIDOME IP panoramic 6000 Series Installation Manual page 15

FLEXIDOME IP panoramic 6000/7000 - outdoor
1.
2.
3.
4.
5.
6.
7.
Bosch Security Systems B.V.
Use the mounting template supplied to mark the position of the four holes. Make sure
that the final position is correct.
Use an appropriate size drill to open the four holes marked before.
Install the four mounting plugs.
Put the PoE cable through the center hole of the mounting plate.
Put the mounting plate in position and attach it with the four screws. The screws must be
5 to 6 mm in diameter (0.20 to 0.24 in.) and equal or bigger than 32 mm (1¼ in.) in
length. Tighten the screws between 4 and 7 Nm (3 and 5.2 lbfft). If the device is mounted
on a wall, make sure that the arrow on the mounting plate points up.
Put the PoE cable through the hole on the camera base.
Attach the grommet to the PoE cable.
Installation manual
Installation | en 15
2019-07 | V01 | DOC