Intec FORCE/3 HP2 Instruction Manual page 16

Machine is on, yet no material
comes out of hose.
Insulation exiting hose is
dribbling out.
Circuit breakers need resetting
often.
T: 303-833-6644
Original Language - English
Slide gate is closed.
Insulation blockage in hose.
Air pocket in hopper is
preventing insulation from
feeding into agitators.
Airlock seal is worn.
Airlock has an obstruction
preventing insulation from
exiting.
Heavy insulation material.
Kink in hose.
Airlock seal is worn.
Low voltage or low amperage.
Extension cord gauge is too
small.
You are using a generator with
high voltage oscillations.
800-666-1611
or
Instruction Manual
Open slide gate.
Turn system off, remove hose
and clear blockage.
Disconnect electrical power.
Redistribute insulation material
inside hopper.
Inspect airlock seals for cuts
and wear. Have a qualified
technician replace airlock seals.
Disconnect electrical power,
remove obstruction.
Push slide gate in 1-2 holes.
Straighten hose.
Inspect airlock seals for cuts
and wear. Have a qualified
technician replace airlock seals.
System requires 115V / 15amp
separate circuit for agitator and
blower.
Use a 12/3 heavy duty (i.e.
SJ300V) extension cord when
length is 100' or less. Use a
10/3 heavy duty extension cord
when length is over 100'.
Purchase a generator with low
harmonic distortion.
www.inteccorp.com
| 15