Intec FORCE/3 HP2 Instruction Manual page 11

When to use variable speed blower control: Most users consider utilizing the variable speed blower
control when performing wall fill applications including blow behind netting, dense pack, or spray on.
The variable speed blower control adjusts the speed for the primary blower only, the second blower is
either 100% on or off; no variable speed for the second blower. By varying the speed of the primary
blower, a user can adjust airflow to precisely meet their requirements. There is no button to turn on or
off the Variable Speed function. It can be adjusted anytime by turning the control up or down as
desired.
If power is interrupted to the system (ex: circuit breaker trips, power cord unplugged and then re-
plugged in, etc.), the POWER ON BUTTON will no longer be lit. This is for SAFETY as the system will not
re-start automatically when power is back to system. In order to re-start the system after a power
interuption, the user will have to press the POWER ON BUTTON.
Example: If a house circuit breaker trips, the system will stop. Once the circuit breaker is re-set, the
system will not automatically start. A user will have to press the POWER ON BUTTON to re-energize the
FORCE/3.
b. Position the System Selector switch to how you
desire to control the system.
i. If you desire to operate by the control panel,
then turn the rotary control switch to
ii. WIRED REMOTE if you desire to control the
system thru the wired remote. Then utilize
the urethane jacketed controls to operate the
FORCE/3.
T: 303-833-6644
Original Language - English
1. BLOWER for blower to come on, and
2. BLOWER / AGITATOR for both the
blower and agitator to operate.
800-666-1611
or
Instruction Manual
www.inteccorp.com
| 10