Javad TRIUMPH-2 Start Manual page 2

TRIUMPH-2 START GUIDE
The Record button starts/stops data re-
cording.
The power port is used to connect the receiver
to an external power source and to charge the batteries.
Input voltage: +10...16 VDC.
The USB port is used for high-speed data transfer and com-
munication between the receiver and an external device.
How to clear NVRAM
1. Turn the receiver OFF with ON/OFF button.
2. Press and hold the Record button.
3. Turn the receiver ON by pressing ON/OFF button.
4. Wait till all LEDs will flashing yellow (except battery LED).
5. Release the Record button.
The bottom 1/4-20" thread connector allows mounting TRI-
UMPH-2 on the monopode, install 1/4-20" to 5/8-11" adapt-
er to mount TRIUMPH-2 on the pole.
2
To turn ON the receiver press
the power button. To turn OFF
the receiver, press and hold the
power button until LEDs are off and
then release the button.