A&D UB-1100BLE Instruction Manual page 15

Wireless Function
 In the unlikely event that this monitor causes radio wave interference to a different wireless station, change the location
where this monitor is used or stop use immediately.
 Be sure to use in a location where visibility between the two devices that you want to connect is good. The connection
distance is reduced by the structure of buildings or other obstructions. In particular, connection may be impossible
when devices are used on either side of reinforced concrete.
 Do not use Bluetooth® connection in the range of a wireless LAN or other wireless devices, near devices that emit
radio waves such as microwaves, in locations where there are many obstructions, or in other locations where signal
strength is weak. Doing so may result in frequent loss of connection, very slow communication speeds and errors.
 Using close to an IEEE802.11g/b/n wireless LAN device may cause mutual interference to occur, which may result in
reduced communication speeds or which may prevent connection.
In this case, switch off the power supply to the device that is not being used, or use the monitor in a different location.
 If the monitor does not connect normally when used near a wireless station or broadcast station, use the monitor in a
different location.
 A&D Company, Limited cannot accept liability for any damages incurred due to impaired operation or data loss, etc. that
occur through the use of this product.
 This product is not guaranteed to connect to all Bluetooth® compatible devices.
English 13