Symbols On The Display - Husqvarna LP 9505 Operator's Manual

LED Indi- Cause
indi- cation
cator
3 Off. The remote control is not connected
to the receiver.
Flash- The remote control is connected to
es the receiver. The main contactor
green. safety relay is off.
On The remote control is connected to
with a the receiver. The main contactor is
green on.
light.
On The main contactor is on. The move-
with a ment of the product is disabled be-
yellow cause the remote control is tilted.
light.
On The main contactor is locked. 1 of
with a these causes prevent operation of the
red main contactor:
light.
• The emergency stop button is en-
gaged.
• The remote control is tilted.
• The joysticks are not in the cen-
ter.
• The configurations menu is open.
4 Flash- The remote control operates correct-
es ly.
green.
Flash- The remote control battery charge is
es yel- low, but the remote control battery
low. can be used for 15 more minutes.
On The battery is empty. The remote
with a control stops the operation.
yellow
light.
On Hardware fault. The remote control
with a found a fault during the start or the
red operation. The remote control pre-
light. vents operation.

Symbols on the display

Alarm. The engine oil pressure is low. The
engine stops.
Alarm. The engine temperature is too high.
The engine stops.
24
Alarm. The hydraulic oil temperature is too
high. The engine stops.
Alarm. The hydraulic oil level is too low. The
engine stops.
Alarm. Radio communication connection
does not operate correctly. The engine
stops.
Alarm. CAN bus 0.
Alarm. Radio communication connection
does not operate correctly. The engine
stops.
Warning. CAN bus 1.
Warning. The machine distance sensors do
not operate correctly. The product
movement and the vibration stops.
Warning. No signal from front or rear
machine distance sensor. The safety
distance increases to 4 m/157 in.
Warning. The remote control is not in the
operation range. The remote control is too
close or too far from the product. The
product movement and the vibration stops.
Warning. The remote control is tilted too
much. The product movement and the
vibration stops.
Information. The glow plugs are in operation.
Information. The hydraulic oil filter must be
replaced.
Information. The air filter must be cleaned or
replaced.
Information. The fuel level is too low.
1423 - 002 - 03.04.2020