Noise Safety; Work Area Safety; Personal Protective Equipment; Fire Extinguisher - Husqvarna LP 9505 Operator's Manual

Table of Contents

Advertisement

Do not breathe the exhaust fumes.
Make sure that the airflow in the work area is
sufficient. This is very important when you operate
the product in trenches or other small work areas
where exhaust fumes can easily collect.

Noise safety

WARNING: Read the warning instructions
that follow before you use the product.
High noise levels and long-term exposure to noise
can cause noise-induced hearing loss.
To keep the noise level to a minimum, do
maintenance on and operate the product as given in
the operator's manual.
Examine the muffler for damages and defects. Make
sure that the muffler is correctly attached to the
product.
Use approved hearing protection while you operate
the product.
Listen for warning signals and voices when you use
hearing protection. Remove the hearing protection
when the product is stopped, unless hearing
protection is necessary for the noise level in the work
area.

Personal protective equipment

WARNING: Read the warning instructions
that follow before you use the product.
Always use approved personal protective equipment
when you operate the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the correct
personal protective equipment.
Regularly do a check of the condition of the personal
protective equipment.
Use an approved protective helmet.
Use approved hearing protection.
Use approved respiratory protection.
Use approved eye protection with side protection.
Use protective gloves.
Use boots with steel toe-cap and non-slip sole.
Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.

Fire extinguisher

Keep a fire extinguisher near during operation.
Use a powder fire extinguisher of "ABE" class or a
carbon dioxide fire extinguisher of "BE" type.

Work area safety

During operation, no one is permitted to be in the
area (A) shown in the illustration. This applies to
bystanders and the operator. The area is between 0
and 2 m/6.6 ft from the product.
A
B
During operation, make sure that no bystanders are
in the area (B) shown in the illustration. The area is
between 2-10 m/6.6-33 ft from the product.
Do not operate the product from a longer distance
than 20 m/66 ft.
Make sure that the machine distance sensors
operate correctly. The product must stop
automatically when the remote control is in the area
(A).
Do not operate the product unless you have clear
view of the product and the work area.
Make sure that only approved persons are in the
work area.
Clear the work area of obstacles.
Do not use the product in fog, rain, strong winds,
cold weather, risk of lightning or other bad weather
conditions. To use the product in bad weather or in
wet locations can have a negative effect on your
alertness. Bad weather can cause dangerous work
conditions.
Keep the work area sufficiently illuminated.
Do not use the product in areas where fire or
explosions can occur.
Page 16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents