Safety Instructions For Maintenance; Safety Instructions For Operation Near Edges; To Do Before You Operate The Product; To Engage And Disengage The Articulation Joint Lock - Husqvarna LP 9505 Operator's Manual

Safety instructions for operation near edges

WARNING: Read the warning instructions
that follow before you use the product.
• There is a risk that the product falls when you
operate it near an edge. Always keep a minimum of
⅔ of the product on a surface that is sufficiently
stable to hold the product weight.
• If the product falls, stop the engine before you lift the
product back to a surface that is sufficiently stable.
To do if the product falls on its side on page
Refer to
29 .

Safety instructions for maintenance

WARNING: Read the warning instructions
that follow before you use the product.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Use personal protective equipment. Refer to
Personal protective equipment on page 16 .
• Stop the engine and make sure that all parts of the
product are cool before you do the maintenance.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.

To do before you operate the product

• Read the operator's manual carefully and make sure
that you understand the instructions.
• Read the engine manual that is supplied by the
engine manufacturer.
• Do the daily maintenance. Refer to
schedule on page 30 .
• Disengage the articulation joint lock. Refer to
engage and disengage the articulation joint lock on
page 19 .
To engage and disengage the
articulation joint lock
WARNING: The articulation joint lock must
always be engaged when the product is
lifted and attached to a transportation
vehicle.
1423 - 002 - 03.04.2020
•
•
•
•
•
•
•
•
•
•
Operation
Maintenance
To
Clean the product to remove dangerous material
before you do the maintenance.
Disconnect the spark plug cap before you do the
maintenance.
The exhaust fumes from the engine are hot and can
contain sparks. Do not operate the product in indoor
areas or near flammable material.
Do not change the product. Modifications that are
not approved by the manufacturer, can cause
serious injury or death.
Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
Replace damaged, worn or broken parts.
Only do the maintenance as given in this operator's
manual. Let an approved service center do all other
servicing.
Remove all tools from the product before you start
the engine after maintenance. Loose tools or tools
attached to rotating parts can eject and cause injury.
After maintenance, do a check of the vibration level
in the product. If it is not correct, speak to an
approved service center.
Let an approved service center do servicing on the
product regularly.
CAUTION: The articulation joint lock must
always be disengaged during operation to
prevent damage to the product.
19