4. Remove the air filter hose (A).
C
B
A
5. Remove the inlet manifold (B). Do a check of the oil
quantity in the inlet manifold. The oil quantity is
correct if there is a thin layer of engine oil on the wall
in the inlet manifold.
6. If there is more engine oil than usual, do these steps:
a) Remove all 3 glow plugs (C).
b) Turn the crankshaft slowly by hand on the front
pulley bolt. As an alternative if you cannot get
access to the crankshaft, turn the fan more than
5 turns.
c) Examine the glow plug holes. If engine oil comes
out of the glow plug holes, turn the crankshaft or
the fan until no more engine oil comes out.
d) Clean the inlet manifold and the air filter hose.
e) Examine the air filter system for engine oil. If
there is engine oil, clean the air filter cover and
replace the air filter elements.
f) Install the 3 glow plugs and the air filter cover.
7. Install the inlet manifold and the air filter hose.
8. Connect the battery cable to the negative (-) terminal
on the battery.
To do a
9. Do a check of the engine oil level. Refer to
check of the engine oil level on page 32 .
To start the product on
10. Start the engine. Refer to
page 25 . The first minutes of operation after a fall,
black smoke can come from the product.
Page 29