Led Indicators On The Remote Control - Husqvarna LP 9505 Operator's Manual

To connect the remote control to the product
with a CAN bus cable
When a CAN bus cable is used, the remote control
battery is not necessary. The remote control receives
power through the CAN bus cable. The CAN bus cable
is always connected to the product. Keep the CAN bus
cable behind the rear hatch when it is not used.
1. Open the rear hatch and remove the remote control.
2. Pull out the loose end of the CAN bus cable from the
rear hatch.
3. Remove the connector cap on the remote control.
4. Put the loose end of the CAN bus cable in the
connector on the remote control.
1423 - 002 - 03.04.2020
5. Tighten the connector screw for the CAN bus cable
by hand.

LED indicators on the remote control

The LED indicators show the state of charge and if there
are problems with the remote control.
LED Indi- Cause
indi- cation
cator
1 On The front machine distance sensor is
with a not in operation.
yellow
light.
2 On The rear machine distance sensor is
with a not in operation.
yellow
light.
1
2
3
4
23