Toro Spray Master Series Operator's Manual page 47

1. If using a trailer, connect it to the towing vehicle
and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Lower the ramp.
4. Align the machine to the ramp and lock the
caster wheels; refer to
13)
5. Back the machine up the ramp
1. Back the machine up the
ramp.
6. Secure the machine; refer to
Machine for Transport (page
7. If your machine has material in the spreader
hopper, install the hopper cover
Securing the Machine for
Transport
WARNING
Securing the machine at any upper frame
location could cause the parking brake to not
function properly, which could cause serious
injury or death.
Only use the front tie-down locations at the
lower frame to secure the front of the machine.
Only use the rear tie-down locations at the
back of the frame to secure the back of the
machine.
Note:
Refer to the chemical-warning-product
label(s) before transporting the machine and follow
all local/state/federal requirements for transporting
chemicals.
Note:
Ensure that the spreader-hopper cover and the
spray wand are secure before transporting.
1. At the left side of the machine, ensure that the
shutoff valve for the sprayer tank is closed and
the drain plug is secure. At the right side of the
machine, ensure that the pump-shutoff valve is
closed.
Caster-Lock Pedal (page
(Figure
Figure 57
2. Walk the machine forward
down the ramp.
Securing the
47).
2. Shut off the engine, remove the key, and engage
the parking brake(s).
3. Block the tires.
4. Use the tie-down points on the machine to
securely bind the machine to the trailer or truck
with straps, chains, cable, or ropes
and
regulations for trailer and tie-down requirements.
57).
g312789
1. Front tie-down points
1. Rear tie-down points
47
Figure 59 or Figure 60). Refer to local
Figure 58
46-inch and 52-inch machines shown
Figure 59
46-inch machine shown
(Figure 58
g313488
g313489