Toro Spray Master Series Operator's Manual page 69

Figure 96
1. 102 mm (4 inch) gap
2. Less than 102 mm (4 inch)
gap
4. If the gap is larger than or smaller than 102
mm (4 inches), remove the knee pad; refer to
Removing the Knee Pad (page
5. Loosen the 2 jam nuts that secure the
motion-control rod at the upper and lower ball
joints (Figure 97).
g317904
3. More than 102 mm (4 inch)
gap
52).
1. Left motion-control rod
2. Right motion-control rod
6. Adjust the motion-control rod as follows:
•
To increase the gap between the speed
bar and motion control lever, rotate the
motion-control rod counterclockwise.
•
To decrease the gap between the speed
bar and motion control lever, rotate the
motion-control rod clockwise.
7. Tighten the jam nuts
8. Repeat steps
control lever.
9. Install the knee pad; refer to
Pad (page 52).
69
Figure 97
3. Ball joint
4. Jam nut
(Figure 97).
3 through 7 for the other motion
Installing the Knee
g313363