Toro Spray Master Series Operator's Manual page 44

7. Release the trigger for the wand and return it to
the tool clip on the machine; refer to
with the Spray Wand (page
8. Move the boom sprayer-control valves to the
O position, set the sprayer-pump switch to the
FF
O position, and shut off the engine.
FF
9. Clean the strainer; refer to
(page 44).
10. Repeat steps 2 through
neutralizers recommended by the chemical
manufacturers; refer to
39).
11. Repeat steps 2 through
Spraying
40).
Cleaning the Strainer
9 using cleaners and
Filling the Tank (page
9 using clean water only.
Cleaning the External Components
1. Using a hose to wash off the outside of the
sprayer tank with clean water.
Note:
Do not use a power washer to clean
the machine. The high-pressure water
may force residual corrosive materials into
spreader-spreader components.
2. Remove and clean the sprayer nozzles; refer to
Cleaning the Sprayer System and Wand (page
43).
Note:
Replace damaged or worn nozzles.
3. Allow the spreader-sprayer to completely dry
before the next use.
Cleaning the Strainer
Service Interval: After each use
Important:
If you used wettable-powder
chemicals, clean the strainer after each time that
you rinse the sprayer tank.
1. Rotate the left tank and right tank return and
suction valves to the closed position
1. Left tank return valve
(open position)
2. Left tank suction valve
(open position)
2. Align a drain pan under the strainer
44
(Figure
Figure 52
3. Right tank suction valve
(open position)
4. Right tank return valve
(open position)
(Figure
Figure 53
52).
g311408
53).
g311413