Re Move Dust - Hasselblad CFV II 50C User Manual

9.1 CLE AN THE SE NSOR FILTER
Caution!
Be careful when you attach/remove the components to/from
the camera. This will help prevent damage to the data bus
connections.
Caution!
When you remove the CFV from the camera, keep foreign
objects away from the sensor as the green IR filter is very
sensitive. This will help prevent damage to the equipment.
Caution!
If you use canned compressed air to clean the glass of IR filter,
read the instructions very carefully before use. This will help
prevent damage to the filter.
Clean the Sensor
1 Remove USB 3 cable if connected.
2 Remove the CFV from the camera by sliding the Lock
Button to the right (when seen from behind). See page
18.
3 Clean the rear part of the camera carefully by using
compressed air.
4 Carefully clean the outside surface of IR filter by using
clean compressed air.
5 Reattach the CFV to the camera or use the protective
cover as quickly as possible.
If compressed air did not remove all the problems and you
still see dust spots in the images, you may have dust either on
the inside of the IR filter or on the CMOS sensor itself, please
contact your Hasselblad dealer.
CFV II 50C USER GUIDE
9.2 CLE AN THE LE NS GL ASS SURFACE

RE MOVE DUST

Caution!
Do not touch the glass surface with your fingers. This can
cause damage to the equipment.
If there is dust on the lens glass, do as follows:
1 Remove the dust with an air blower.
2 If that does not solve the problem, try to remove dust with
a very soft lens brush.
RE MOVE SME AR
Caution!
Do not touch the glass surface with your fingers. This can
cause damage to the equipment.
If there is smear on the lens glass, do as follows:
1 If you are not sure how to remove the smear, contact your
local Hasselblad authorized service centre.
2 Clean the lens glass with a high quality lens cleaning
solution on a tissue.
CONTENTS
APPENDIX
110
www.hasselblad.com