TransAct ITHACA 80PLUS Operator's Manual page 30

Series 80PLUS Operator's Guide
You may want to test the printer to ensure that it is running properly. The
sample on the following page shows what a printout of the test may look
like. The test pattern varies depending on the printer model and the
character set selected when the printer was ordered.
Run the test after loading the paper, but before connecting it to a host
system. If the characters do not print properly, check to make sure the
paper is installed correctly.
If the printer is still not working correctly, contact your dealer or the
Technical Support Department at TransAct. For more information,
see "Contacting TransAct's Ithaca facility" on page 2.
1. Plug the DC power cord from the external power supply into the printer.
2. Plug the AC power cord into the external power supply.
3. Open the printer cover.
4. Plug the AC power cord into a grounded three-prong power socket.
5. The status LED will start flashing after approximately six seconds.
6. Insert a roll of paper into the printer. Leave some paper
sticking out, and close the paper cover.
7. The printer will print some technical information.