Maintenance - Husqvarna LP 6505 Operator's Manual

2. Set the throttle control to idle speed.
3. Let the engine operate at idle speed for 2–3 minutes.
4. Set the throttle control to the stop position.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
General product maintenance
Make sure that there are no fuel or oil leaks.
Clean the product.
Make sure that nuts and screws are tightened.
Examine the throttle control and the control for forward
and rearward movement for damage.
Make sure that the throttle control and the control for for-
ward and rearward movement can move smoothly.
Lubricate the controls and linkages.
12
5. If the engine has an electrical start, do also these
steps:
a) Turn the ignition key to the stop position (A).
b) Remove the ignition key to prevent accidental
start.
The hydraulic parking brake automatically engages
when the engine stops.

Maintenance

X = The instructions are given in this operator's manual.
O = Refer to the instructions in the engine manual
supplied by the engine manufacturer.
Before use,
each 10 h
*
X
*
*
*
*
Weekly, Monthly,
each 100 h each 250 h
1364 - 001 - 25.03.2020
A
Yearly, each
500 h