Maintenance - Husqvarna Blastrac EBE 500 Operator's Manual

Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
WARNING:
equipment when you do servicing and
maintenance. Refer to
equipment on page 7 .
WARNING:
maintenance, stop the motors and
disconnect the power plug from the power
source. Make sure that all drives stop.
General product maintenance
Empty the dust collector.
Do a check of the of the sepa-
rator and the separator tray.
Make sure that the power plug
and extension cable are in
good condition and not dam-
aged.
Do a check of the electrical
components, the cables and
the connections for wear and
damages.
Do a check of the Residu-
al Current operated Device
(RCD).
Examine the motors for dirt and
damage.
Make sure that the dust collec-
tor hose is not damaged and
that there is no blockage.
Do a check of the control cage
and blast wheel blades for
To remove the
wear. Refer to
impeller on page 20 .
Clean the product.
Do a check of all safety devi-
ces.
2107 - 001 - 27.07.2023

Maintenance

Before you do
Use personal protective
Personal protective
Before you do the
Each 3 h
*
X
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not
a service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarnaconstruction.com.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
12 h after
Daily
servicing
*
*
*
*
*
X
X
X
Each 3
Yearly
months
19