Connecting A Second Encoder In Sinamics - Siemens SIMATIC S7-300 Product Information

Expert Functions
5.4 Activating a Second Encoder
5.4.2

Connecting a second encoder in SINAMICS

Introduction
Prepare your project as described in the "Commissioning (Page 15)" chapter of this
product information so that an appropriate HW Config hardware configuration and a
NetPro network configuration are present.
The steps that deviate from the "Commissioning" chapter start with the creation of the drive
and the selection of the encoder. These steps are described in the following section.
Procedure
1. Start manual configuration of the drive and open the "Encoder 2" tab in the
2. Click "Encoder data" to specify the second encoder, which in our example is connected to
148
"Configuration" dialog.
the drive spindle.
Connection of the SINAMICS S120 to the Technology CPU
Product Information, 09/2011, A5E00480378-04