Siemens SIMATIC S7-300 Product Information page 56

Commissioning
3.4 Configuring the drive components
Configuring with Smart Line Module (SLM)
1. In S7T Config, open the SINAMICS S120_CU320 folder, and double-click the
2. Insert the control unit and optionally the add-on modules, for example TB30 terminal
3. For the selection of the SINAMICS infeed, you can choose between modules with or
56
"Configure drive unit" entry or the drive.
board. Select the desired values and click "Next" to confirm the settings.
without DRIVE-CLiQ connection. Select the appropriate setting and click "Next" to confirm
the setting. The following steps are for Smart Line Modules without DRIVE-CLiQ.
For modules with DRIVE-CLiQ infeed, proceed as for the configuration with Active Line
Modules (ALM).
Connection of the SINAMICS S120 to the Technology CPU
Product Information, 09/2011, A5E00480378-04