Install Oil Pressure Switch; Install Intercooler; Install Intercooler Inlet Pipe - Toyota pmn Installation Instructions Manual

50
R
K
K
K
K
K
45˚
K
K
K
K
K
K

5. INSTALL OIL PRESSURE SWITCH.

(a) Install the oil pressure switch into the adapter using
Loctite 243. Use SST 09816-30010
R: Pressure switch
Torque: 13 Nm
(b) Connect the oil pressure switch connector to the
pressure switch.
NOTICE: Turn oil filter until the o-rings touches the
flange. Turn oil-filter 270

6. INSTALL INTERCOOLER.

(a) Position the intercooler assembly underneath the
gearbox.
K: intercooler (7-1)
(b) Install the bolt M8 x 12 into the gearbox side to fix the
bracket. (hand tighten)
K: Bolt (7-6)
(c) Install the bolt M8 x 20 into the gearbox front to fix the
bracket (hand tighten)
K: Bolt (7-8)

7. INSTALL INTERCOOLER INLET PIPE.

(a) Position intercooler inlet pipe, 2 hoses and 4 hose
clamps.
K: intercooler inlet pipe (6-1)
K: Hose turbo side (6-2)
K: Hose intercooler side (6-3)
K: Clamp (4 pcs.) (6-4)
(b) Tighten outer hose clamps on turbo charger side and
intercooler side.
Torque: 3 Nm
(c) Pull inlet pipe 5 mm out of the hoses on both sides and
hand tighten inner clamps.
(d) Install the inlet pipe with a bolt to the engine.
K: Bolt (6-5)
Torque: 12 Nm
(e) Tighten the inner hose clamps.
Torque: 3 Nm
°
by hand.