Installation Procedures; Introduction; Si Unit; Caution * Notice * Hint - Toyota pmn Installation Instructions Manual

Lhd/rhd turbo kit
Table of Contents

Advertisement

26

INSTALLATION PROCEDURES

1.

Introduction

1.1. SI UNIT.

The UNITS given in this manual are primarily expressed according to the SI (international System of Units), and
alternately expressed in the metric system and in the English system.

1.2. CAUTION * NOTICE * HINT.

CAUTION: There is a possibility of injury to you or other people. Be sure to observe the contents.
NOTICE:
There is a possibility of damage to the components or vehicle. Be sure to observe the contents.
HINT:
Additional information to help you perform the installation correctly and efficiently.

1.3. DEFINITION OF SYMBOLS.

U:
Part or parts that will become Unnecessary after removal or disassembly.
K:
New part or parts from the Kit that will be used for installation or assembly.
The numbers in the text and in the illustrations (Ex.4-C) which follow this symbol correspond to numbers in
"PARTS LOCATION" and "No." in "PARTS LIST".
R:
Part or parts that has/have been removed from the vehicle and will be Reused for installation or assembly.

1.4. WATER HOSE AND CLAMP.

NOTICE:
Follow the instructions below. Otherwise the hose may come off or the coolant may leak from the
connection, resulting in engine overheat.
Example:
3-5mm
(a) When fitting the hose, mixture of water and L.L.C.
Paint mark
(b) The paint mark on the water hose is the reference for
(c) When fitting the hose to the pipe, make sure to push in
3-5mm
(d) Unless otherwise specified in this manual, f it the hose
HINT:
Do not wrap the hose clamp around the hose at a slant.
(e) When both the water hose and hose clamp are reused,
(50: 50 to 100: 0) can be used for lubrication.
positioning. Unless otherwise specified in this manual, fit
the hose with the mark at the top.
the hose until it reaches the paint mark. If there is no paint
mark on The pipe, push the hose to the end.
clamp at 3 to 5 mm (0. 1 1 8 to 0.197in.) from the end of
the hose while making sure the tabs do not interfere with
any other parts.
make sure to fit the hose clamp at the mark left from
previous clamping.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mr 21zz-fte

Table of Contents