Oil-Sump Preparation; Install Oil Return Adapter; Cleaning - Toyota pmn Installation Instructions Manual

5.

Oil-sump preparation

Ø 4 mm
Ø 6,5 mm
Ø 12 mm
K
K
K
K
R

1. INSTALL OIL RETURN ADAPTER.

(a) Mark the position of the oil return hose adapter.
(b) Punch-mark the drilling position.(spot-weld position)
(c) Pre-drill a 4 mm hole.
(d) Pre-drill to 6.5 mm
(e) Drill the hole out to 12mm.
(f) Remove burrs.
(g) Install the oil return adapter with the nut and copper
gasket and Loctite No.270
K: Adapter (14-1)
K: Nut (14-2)
K: Copper gasket (14-7)
Torque: 45 Nm
(h) Install the oil drain plug with a new gasket.
K: Gasket (14-7)
R: Oil drain plug
Torque: 37 Nm

2. CLEANING.

(a) Remove all liquid gasket remains from the contact
surface.
(b) Clean the oil-sump in a parts wash system to ensure
all gasket and drilling particles are removed.
NOTICE: Check if the gasket contact surface is
straight and clear due to removal
activities.
33